LM399 DATASHEET PDF
LM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for LM LM LM – Precision Reference, Package: TO, Pin Nb=4. The LM series are precision, temperature-stabilized monolithic zeners offering. Title, > 5V. Description, Precision Reference. Company, Linear Technology Corporation. Datasheet, Download LM datasheet. Quote. Find where to buy.
|Published (Last):||16 February 2014|
|PDF File Size:||8.68 Mb|
|ePub File Size:||7.7 Mb|
|Price:||Free* [*Free Regsitration Required]|
Sign up using Email and Password.
Because of the bootstrap, the zener impedance is of much less importance to line regulation than it would be if the K was reduced to provide all the bias. While looking at the LM datasheet, I noticed on the portable calibrator application there is a 5k resistor between the output of the opamp and the noninverting input.
Pricing displayed for Evaluation Boards and Kits is based on 1-piece pricing.
The various ranges specified are as follows:. Post as a guest Name.
LM Datasheet(PDF) – Linear Technology
Sign up using Facebook. A 10V buffered reference application is shown below.
Again on the diagrams: The K is used to for start-up- it has to ensure that the input voltage to the non-inverting input exceeds any negative offset voltage of the op-amp, otherwise the circuit may not start up properly.
LM Datasheet(PDF) – National Semiconductor (TI)
International prices may differ due to local duties, taxes, fees and exchange rates. One could top it off with a Petri dish?
With best regards Andreas. Genius is one percent inspiration, ninety-nine percent perspiration Thomas Alva Edison Temperature Range This is the acceptable operating range of the device.
Please Select a Region. So I tried wrapping my brain around making a high-side current source, and this is what I came up with: The LM requires that its operating current is between llm399.
The various ranges specified are as follows: For more information about lead-free parts, please consult our Pb Lead free information page. Andreas Super Contributor Posts: The voltage may not be very accurate during start up but it will be a few volts and the op-amp will produce some amplification and then deliver enough current through the 5 kohm to properly bias the LM Andreas on May 24, Sample availability may be better than production availability.
ADC which can accept a 7V ref? PCB is on the table aka.
If a model is not available for web samples, look for notes datashfet the product page that indicate how to request samples or Contact ADI. I’m initially choosing an LM target of Pin Count Pin Count is the number of pins, balls, or pads on the device. Rather, I’ll achieve trim by adjusting the current driven through the LM zener. Transit times from these sites may vary.
Andy aka k 10 Hello, this is 2nd part of: I was going to ask why they don’t have it on the other circuits link the one at the very top “10V Buffered Reference” but your last sentence answered that for me thanks!